




I wanted to make my final model thicker than the bottle so that it can be hollow and perhaps accomodate my grymn troops within the interior with a fold down rear door, or maybe side openings for door gunners. So I cast the bottle in two halves, each half more than half the thickness of the bottle (it makes sense to me!).
You can see from the pictures above that I have problems with air bubbles - these are in the rubber mould itself and not the resin, so I have to take more care with that in the future.
My intent is to detail two halves of the resin casting, add swivel engines to the sides and a front cockpit section where the bottle neck is, add a rear door, and then make a mould for the complete model so that I can cast a number of them. Who knows, I may even put a few on ebay and see if they sell!